Rolling molding equipment operation to release the billet, billet work plans and take: in the device before use, inspection connections in solid, installing bolts and nuts are tight, so chassis should add a little oil powe Roll forming machine hand release billet, billet work plans and take: in the device before use, inspection connections in solid, installing bolts and nuts are tight, so chassis should add a little oil testing machine, the first time I run in vain watch carefully, with or without the vibration and noise, oil window oil, motor coordination, and part in order to install all the normal mould, mould installation, shall be immediately switch off the power supply, hand move with or gear motor, so that transform table, and rise to the top of the slide seat, had better have an object to support the bottom of the table and sliding down the seat between natural, cause accidents prevent slippery. The machine features: the rolling molding equipment operation, maintenance and mechanical maintenance, and testing of superiority, easy change of the mould; Automatic control system adopts the unit highly integrated network, automation system and better performance; Device adopts advanced automatic control software, production information management. Ceramic tile stamping mould design, is used in the mold and six in the same standard size model, the first installed modules and reduce death, lower die installed directly on the table of six-wheel model installed in the bottom surface of the slide and place the thickness of the right upper and lower plate, ensure mould clamping, four uniform gap, the distance, around the thickness of ceramic tile die is blank. Then based on the model, transform form, installed in die to pay the remaining five, all installed in order to promote the upper and lower after pressur mould